| EXTERIOR
SURFACE SALT REMOVAL TESTS |
| Two tests were
conducted. |
Test 1. Removing
chloride from a surface by rinsing with water only and
Test 2. Removing chloride from a surface with Salt-Away
then rinsed with water.The surface utilized was sheet
metal painted with marine epoxy paint on which sea water
had been sprayed.
Surface analysis test showed that
the sheet metal contained 80ppm chloride after the sea
water appliction.
|
|
Test 1. The surface
was rinsed off with distilled water for 15 seconds, then
collected.
Test 2. Salt-Away (1 part to 128 parts water) was applied
first, rinsed with distilled water after 10 minutes. Water
sample was collected after 15 seconds of rinsing. |
| TEST
RESULTS |
The Titrators image shows
the results.
Test 1. distilled water only shows 4.6 units (34%) chloride
in the rinse water sample.
Test 2. Salt-Away shows zero units (0%) chloride in
the rinse sample.
Salt-Away successfully passes
the ISO 8502-10 standard for removal of salt from a
surface. (Standard .005% or less chloride remaining
in the rinse water sample.) |
 |
